Routing

Hi,I have a layer 2 switch 2950, and a router 2811, can I know if there is virus attack on one PC (IP: 10.33.33.1) i will be able to know where it coming from?My customer basically wanna to pin down the PC who is being infected.Thanks.

Dear All,I am finding very high CPU utilization for cisco 3640 series router having version "c3640-io3-mz.124-12.bin"Please find attached the SHOW PROC CPU command result. I could not figure out which process is taking this much CPU utilization, can...

Hi, I have a 2M ATM circuit on RJ45. Is there any special requirement for a 2811 with AIM-ATM module to use the ATM circuit? Any sample config?

hi,this is my scenario, cisco 1841 router with a DSL line through ethernet port(working) & and now i just connected a T1 line through a built-in csu/dsu, how should i got about this to create load balance between this two connections?

Hi all,my question is:I have two routers back-to-back connected, I configure on interfaces two different MTU (1500 on one router, 4470 on other router).Why if I do a ping with a size of 1600 the ping fail?ThanksMassimiliano

hi,I have typical requirement which is driving me to use dual ospf process on my cisco 7206 npe g1 routers. Suggest me if its advisable or not and would i be able to achieve my requirment .My setup is ( as seen in the diagram attached ), I have two r...

Dear all,Observe the packet drop for file transfer application only, not to other protocal. there is no limitation setting on the routers, anyone encounter the same problem before?thanks

I recently purchased (2) 2821 routers w/ 512MB of ram.I'm planning on running the following:BGP w/ default routes onlyNetflowIOS IPS w/ basic signaturesWill my routers handle all of this?Thanks in advance.

Does the 3750 support NAT? I'm pretty sure the SMI/ipbase image doesn't, but what about the EMI/ipservices image?Thanks,Matt

Is there anything available on the net on how to set up an 871w other than George Ou's templates at techrepublic? I'm looking for something a little more on the "hold my hand" side of things...Jay

HI,Would you tell me the link or procedure to upgrade my cisco devices.Those devices have not been upgraded any more.Thanks in advance.bikash

Hi , Is their any command which makes the line protocol on a serial interface down, without shutting down the serial interface...am using a cisco 2600 series routers..thanks in advance....

HiiI m facing problem in cisco 3745 series router in which one E1card (VWIC-2MFT-G703)is not functioning properly & Fluctuating.Please advise me what is the possible cause for this & how to resolve same.Thanx

Hi,What is the quickest way to find the latest GD release of Software for a 2811 Router?I'm on the http://tools.cisco.com/ITDIT/CFN/Dispatchbut it takes long to find what I am looking for.