Routing

Hi,I am testing VRRP and it seems to work very well. Below is my configR1-3640 Primary RouterR2-3640 Secondary RouterS1-2960 Internal SwitchS2-29?? External SwitchI have a single ethernet drop from our colo provider, I will have it go into a switch t...

Hi all-My two border routers are set to be returned off lease in a few months, and am just getting around to budgeting the new ones. I wanted to come here to get a general feeling of what I should replace my current equipment with.Right now we have ...

I have a router with a WAN connection to a RIP network, and I am redistributing RIP into BGP, I have a eBGP neighbor off my redistribution router. On my RIP route when it gets to my eBGP neighbor I get a metric set of 1 on my route. 10.133.160.0/2...

Hi,I have flash memory chips here but no way of telling what size they are. How would one know what the size of the flash module is before putting it in the router?

Hi I have a quick question I have a point to point frame relay circuit and at night an FTP run that floods this circuit causing it to be unusable till the FTP is finished. Question is how do I configure QoS on it so I can make the FTP a low priority...

Dear sir,i have a 7606 router, and i want to know how to connect E1 line to this router, what is the module that i must install on this router to connect E1 on it.Thanks

Hi,Here's the scenario- we have 2 ISP- we have 2 LAN, we need to let one of the lan (192.168.1.X) to go to ISP1and the other (192.168.2.X) to ISP2if ISP1 goes down, all lan should go to ISP2if ISP2 goes down, all lan should go to ISP1We've used the a...

The router has a reset button on the back. How long do I need to hold it in for? The router displays wingdings on console. Tried changing the baud rate to lowest(2400) still nothing.Could the console port be busted?

Does anyone know how to tell what Version of WIC1-DSU-T1 card is installed? We have a 3745 and are looking to move to a 3845 but we need to know if our cards are compatible.

where can i find a template config to configure a 1721 to ISa ipsec tunnel and what ver of IOS is required for the 1721?ThanksBrad

Dear All,my mail server is on 192.168.1.9, all of my users are ONLY ALLOWED to retrieve email from my mail server, but for some of VVIP in 192.168.1.240/28 I need to allow them to retrieve their email from internet pop server (ie. hotpop .. etc)how ...

Reg:Backup VPN over Internet+InternetLinkTotal Link Bandwidth: 10000KbpsSingle Link = Internet + VPN LinkMux---->Wired Conn..---->Internet RouterEurope - India --->Logical VPN TunnelMy Internet-int B/W given as:10000My VPN Tunnel B/W given as:10000Co...

Hi, What Interface we use to connect to an IPLC circuit? Is that an G.703 interface(E1) or a v.35 (normal Wic-2T cards) ?Appreciate your response.RegardsNavneet