Finding accurate answers to your questions and issues is always gratifying, but what if these answers are shared globally across different languages? The Cisco Community team has been working on a proof of concept (PoC) to take Accepted Solutions in...
ISP A-> 2Mbps link terminated at 36XX router with IP block XX.XX.XX.XXISP B-> 2Mbps link terminated at Juniper M20 router with IP block YY.YY.YY.YYMy plan is hook webservers behind above two WAN links.Requirement: WAN links must work as loadsharing a...
can anybody sent good understanding document about Mpls
one telecom company is having 3640 router at one end & 1601 router at other end. for e1 connectivity they r using RAD FCD-E1 modems. in earlier configuration FCD-E1 modem has been configured for using 1 timeslot for data remaining 29 for voice. now c...
Hi I have an exchange server in my lan,with an invalid ip address,I want to make it avaiable via my valid ip address but I want to create a nat to access this server.I dont know how can I write this config on my router,,please give a config hint,,reg...
Hello,What username and password is required on switches so you can browse to them via http?rgdsPhil
The 3640 goes into rom monitor mode after error messagedevice does not contain a valid magic numberboot: cannot open "flash:"boot: cannot determine first file name on device "flash:"IOS on flash is currupted or flash memory is currupted?
I have a CISCO 871 Router, The enternet port responds for a minute after putting the router on and after that the ethernet port stops responding.even the ethernet link LED also doesn't blink.Is it a hardware or software or installation problem. if it...
dear all,i have 2 1841 routers and 2 WIC-1T cards.initially i applied for a point to point leased line but provider said they cannot provide a leased line and finally they provided HDSL line, from the isp side they came and installed SHDSL BNC connec...
I know it is not a cisco documentation , but I just want to compare the concept http://www.foundrynet.com/services/documentation/srIPv6/IPv6_RIP.html[cut]BigIron(config)# interface ethernet 3/1BigIron(config-if-e100-3/1)# ipv6 rip metric-offset 1BigI...
WHat are the major differences between a 7600 and 6500 chassis?
I have two 1841s which have a working L2L tunnel. I'd like to bring up a remote PIX as another L2L that terminates on the local 1841. THe configs look good, but no traffic every matches the access-list for the PIX side? Ideas?
What's the best way to determine if a switch can handle traffic? I have a 2908 switch set up for high availbilty, but I am not sure if it will handle the traffic load. We avearge about 15mb a day and sometimes go up to 30mb during high traffic.
hi alli have a 1841 cisco router with 2 port analog module, one pc will dial using motorola or us robotics modem to this 1841 router.is there any sample configuration for this setup.all posts will be appreciated with ratingsRegdsBinoy
Hi, I need to convenice on of my customer that below message is cisco message or just bootup message& it is not memory problem.Please suggest Smart Init is enabled smart init is sizing iomem ID MEMORY_REQ TYPE 000092 0X000B3280 C2600 Dual Ethernet ...
Is it possible to connect an 828 router on one end and an 878 on the other using G.SHDSL? I understand that the G.SHDSL interface of the 828 uses 2 wires, while the 878 uses 4 wires. Our company uses quite a number of 828 routers and we are looking t...
