Routing

I am getting the error below on a ADSL WIC in a 1751 router, anyone know what it means?Oct 10 11:55: 22.275: Vi2 LCP: State is ClosedOct 10 11:55:22.275: Vi2 PPP: Phase is DOWNOct 10 11:55:22.275: Vi2 PPP: Phase is ESTABLISHING, Passive OpenOct 10 11...

The CMS plug in for my 2950's is getting an applet error. ANY ideas? I really need this or something to monitor the switch.

Hello, Is there a command that will tell me how many of the 4 memory slots are being used. The router has 64Mbs and I want to upgrade it to 128Mbs. Thanks.....

I am trying to apply TCP Intercept to my serial int on the border router. When creating the ACL for TCP-I, is it effective for In-bound traffic only or In and Out? I am also debating between Watch Mode and Intercept. I want to use Watch at first b...

Dear all,I'm facing lot of errors and CRC on LAN interface. any one can help to determine the problem where,I'm connecting Fastethernet to Mentat accelator and then to PIX firewall. all interfaces touch the router configured full duplex and 100Mbps. ...

Can these ISRs, with their firewall and VPN hosting capabilities, replace the need for a separate firewall, such as a PIX?

What is considered to be the max number of point to point T-1s that can be added to a site before another option is considered? Four? Also what would be the next step in point to point bandwidth? Frantional DS3?

I've 3 branches connected to MPLS IP VPN. Each branch have own private AS connected to ISP's AS.Two branches connected to each other.For example AS1 connect AS2 and both connected to AS11111(ISP). I want to advertise one route by both AS but use only...

Hi, I'd like to know a router like a cisco 2821 can handle a E3 card processing almost 5mega/s voice packets, together with data traffic?Or it would be better to use a 3825 (cost is a factor).its also running BGP (medium size table), ospf (small data...

Anybody know how many VPN tunnels the 1841 supports WITHOUT the AIM-EPII-PLUS Module?

Hi, i am looking for router which should support minimum of 4 ports WAN links(2Mbps leased line x 4 Nos.) apart from cisco 1700 series router.but not more than 2800 series routers. looking for good & economical one.

I have this 871 series router and have lost the IOS image on flash. How do I get another image on the router as it is on ROMMON now. I tried xmodem and also tried copy the IOS through the USB port, still no success.

Does anyone know if there is a Cisco router that will support UMTS/GPRS. We are looking for a way to support the routers in the field if all access to the router is gone