Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

I have 2 core switches and I have configured HSRP switch 1 is active IP address is 10.44.16.2 and switch 2 IP address is 10.44.16.2 and my Vir IP address is 10.44.16.1. HSPR for VLAN interface  The host connected to my dis switch from the morning I'm...

Hello, Is there a difference between these two cables? A920-CONS-KIT-S, found on this page:https://www.cisco.com/c/en/us/td/docs/routers/asr920/hardware/installation/guide/b-asr920-ic-hig/b-asr920-ic-hig_chapter_0101.html A900-CONS-KIT-S, found on th...

Hello experts !i am doing dmvpn with dual hub but the problem is HO-primary router is all OK but HO-secondary router is malfunctioning. HO-secondary & primary & branch is configured with EIGRP broadcasting the tunnel and LAN network.HO-primary & bran...

Hello. I'd appreciate any assistance solving the following problem. This is a basic layout of the network:EDIT: I'm working with real devices, not on Packet Tracer.  Wireless clients on VLAN 200 obtain IPs from a DHCP server on VLAN 1 through a route...

Capture.JPG
tresdodi by Level 1
  • 10865 Views
  • 13 replies
  • 5 Helpful votes

Hello, we want to use BGP multipath to share the bandwidth of WAN connections, but traffic is encrypted with GetVPN. Anybody has used this, can the features be combined? Best Regards,Christian

hi! we have cisco 891 router which is not working PoE ports.Does it need to be activated? If so, how can it be done. #show versionCisco IOS Software, C800 Software (C800-UNIVERSALK9-M), Version 15.4(3)M, RELEASE SOFTWARE (fc1)#sh invNAME: "C891F-K9",...

Hi all,I'm having an issue with a few users who need access to a URL.  Basically I have a PC on a vlan with an ip address of 10.55.102.44.  They need access to a site with an ip 169.254.9.53.  The traffic isn't getting as far as our firewall to allow...

lquinn by Level 1
  • 2027 Views
  • 12 replies
  • 0 Helpful votes

Hello, I am currently having issues with a router having PAT configured. It works well for a moment but after a couple of hours, the router stops working becuase it has a lot of active translations (200K or more). Take in mind that this is a backup r...

morabusa by Level 1
  • 1897 Views
  • 8 replies
  • 0 Helpful votes

I am trying to form dmvpn between HEAD-OFFICE (primary and secondary router) & BRANCH but dmvpn is up only with HEAD-OFFICE-PRIMARY router & BRANCH router. NO any dmvpn is formed between HO-SECONDARY router. The config & topology is attached below: N...

We are facing problems with NAT and DNS can anyone help us with proper guidelines. Problem Summary :1. In2out packets after certain amount of translations per host.2. Frequent DNS failures. Brief description of the fault:Hope you can help check on a ...

apon.reza by Level 1
  • 724 Views
  • 1 replies
  • 5 Helpful votes

I always appreciate the support of Cisco community. There are 3 (or more) networks that need to access the server A and B (below picture). For your information, there are all standalone networks, not external network. We've faced IP duplication probl...

Network Diagram.JPG
Review Cisco Networking for a $25 gift card