Routing

Hi all, I am having a problem in connecting HSSI cable back to back for 2 Cisco 7206 routers. I ve configured the interfaces as below.RouterA:interface Hssi6/0 ip address 192.168.1.1 255.255.255.252 load-interval 30 hssi dce serial restart-delay 0 cl...

I have a scenario were a wireless high site has multiple wireless links back to the core network. One of the links is a 30mbps+ stable link, the other is a 7mbps link with limited capacity available.OSPF is causing routing across the link (the 7mbps)...

Anyone know whether the IOS SP service able to support DLSW ?How about IOS Enterprise Service ?I need IOS to support voice over frame-relay and DLSW protocol.

does anyone have a link to some config examples for T1 load balancing on 2620? I've got the basics, just looking for some additional info.

Hi!! i am bit confuse on a simple routing thing.........i am working on one of the sites.....we have 4 sites around the world.......now i want to configure my router for reduenduncy......as on wan link i am gonna use FR (2mbps)......as a backup i...

Currently I am debating a router upgrade at our colo. The routers in question are border internet routers at the moment, connecting us to the ISP (Via Ethernet). The router uses Ethernet connectivity for the primary route path, but supports about 3 M...

I have a VPN tunnel setup between a Watchguard Firebox and a Cisco ASA (7.1).Since IPSec won't allow multicast traffic, how do I get the routers on the ASA side populated via OSPF?I added the route to an OSPF router, but since it's a link-state proto...

Hi,We are currently running off of a single MIS T1 and have a Pix 515E and a Cisco 2800 Series router.We have ordered and received a new Dual-T1 MIS. I added 2 serial cards to my 2800 and and additional ethernet port to my Pix 515eOur existing MIS T...

Dear All,I have 6509 switch. In its first slot present 10/100 ethernet module is there.I have to remove this module and insert 10/100/1000 ethernet module.Can I have some valid suggestions:1 Like these are the precautions needs to be taken2 Like Thes...

I have a Cisco 806 router with the firewall IOS release 12.3(20). The Internet connection is Road Runner cable. Upload speeds are what they should be, 375 kbs to 484 kbs, but the download speeds are terrible, usually around 175 kbs. When attaching...

Hi guys,when is used the cost community? When is better than local preference in the best path selection process?Thanks for your supportRegardsAndrea

What is the difference between ip load-sharing per-packet vs mls ip cef load-sharing full ? I have two wan links and we we want to utilize both link at all time. Thanksaltaf

Dear All,In my network set up we have to take new OC-3 connection on our backbone router(3800) for customer's backhaul connectivity.Our Service provider will give us ATM connectivity.Which will terminate in OC-3 port of router.I have some doubts abou...

Hi,I have 2 x 7507s that provide our internet connectivity. It was noticed that they are both incrementing their BGP table numbers at more than one a second. (sometimes quite a lot more)I've tried to use the command show ip bgp flap-statistics but t...