Routing

Hi thanks for your attention. I config policy-based route on 3750 just like this : no aaa new-model switch 1 provision ws-c3750-24ts vtp domain vtp-a vtp mode transparent ip subnet-zero ip routing ! ip dhcp pool vlan1 network 192.168.0.0 255.255.255....

Hello,I'm have Cisco 871-K9SDM version: 2.3IOS version: 12.4(6)T2In the URL Filtering section router says:Application Firewall unavailable.The IOS image in your router does not support the requested feature. To configure the feature, you need to go t...

Hi,Can someone pls let me know how the cisco WCCP works ?Did some searching ,but didnt get much info.thanks in adavnceThomas.

Hi we are going to implement firwall security C515 on our techncal centre , i need some doc for this plz send us some link for for this.Thanks

When trying to send an e-mail from the SMTP server on the DMZ to the mail server on the inside network, the mail is not delivered. Is this due to the fact that the firewall can not route the message to the mail server? If so how can I get around this...

Hello guys,On my NAS there is a NetFlow collector (ndsad). And because NetFlow is sent via UDP, some info on traffic may be lost. RADIUS accounting is not good for this purpose too. If the channel is not stable enough, how to pick up statistics from ...

Hi,We have a connection between our border router and the gateway firewall through the router's ethernet port and a connection to our ISP host through the router's serial port. The serial interface is fine but the ethernet interface shows a lot of co...

I just started with a company and trying to improve performance across 7 pvcs in a frame-cloud. I have a 3845 with a bonded 2xT1(3088mbps) connection into frame cloud. The 7 remote sites connect into the frame cloud at varying speeds T1, 768, 368, th...

Does a full point to point T1 line transfer at 1.5 MBPS full duplex transmit and receive simultaneosly?So in other words can you transmit 1.5 MBps of traffic while you are receiving 1.5 Mbps at the same time on a T1.This guy at this service provider ...

I've found some multilink ppp configs that look great, but it doesn't look like it will work with my hardware setup. We are currently running a T1, and need to upgrade to a bonded 3meg connection. I'd really appreciate some suggestions. Here's some o...

Is the GEIP+ int processor hot-swappable?Cisco docs do not say specifically, but mention "online installation"..??

hi everybody I know that source routing is implemented in routers by Policy route-map . But I want to have this feature on switch.could you pls help me that how can I set source routing on switches . thanks

I would like to have my switch handle interVLAN communication instead of having my router handle the in flux of packets by setting up sub-if's on the router for the two interfaces I to communicate to and from. Would this be the correct syntax or comm...

situation:VLAN1 active without IP addressVLAN8 shutdown without IP addressproble:if i configure VLAN 8 with an IP address and then activate the VLAN ( NO shutdown command ) the following happensVLAN8 becomes active but VLAN1 suddenly shuts down ???If...