Routing

hi:we have 2 ISP belong to 2 different AS, I can control the outgoing traffic, but how to control the incoming traffic without changing anything at ISP end?

Currently, we have a router with VWIC-MFT-T1. Can this interface supports E1 local loop handoff from local provider given that the speed we subscribed is sub-T1/T1 rate (1.5M or less) from the local provider?Thanks.

Hi,I want to achieve 50% out of physical interface is allocated for Voice traffic and the remaining 50 % allocated for class-default...I was wondering either is it appropriate or best practise to use the max-reserved bandwidth command to override the...

I have two 6509-E core switches connected to each other over WAN through E1 cards, I need to enable L2 switching and full broadcasting traffic between the two core switches and the sites LAN users. Please help

Hi,I wanted to monitor interface status through SNMP. We have SNMPc server, that will send mail alerts whenever device is down. In the same way I wanted to get traps for interface up down.So what configuration required in router to generate traps for...

In http://www.cisco.com/en/US/customer/tech/tk713/tk237/technologies_configuration_example09186a00800942f8.shtmlit states that the 'access rate is the physical line speed'.Does this mean that the access rate for a 256k fract T1 is still to be treated...

I'm trying to configure two Point to Point links that if one of them goes offline the other take its place. What kind of routing protocol you recomend?Those links will both finish in a router 831 in the branch side and 3745 in the HQ Side.

I would like to send FTP traffic over our T1 line and all other traffic over a DSL connection. Our DSL connection is on F0/1 and our T1 is on Vlan1. Nat shows that ftp traffic is translated to the IP on Vlan1 but from there it appears that it doesn't...

Hi,I have a 2611 set up with NAT and the throughput is under 1mbit/s. Is this normal for this router? If I plug in my laptop directly to the WAN I get an 11-12mbit/s connection.Config:version 12.3service timestamps debug datetime msecservice timestam...

Thanks Palaniappan and Rick.As it was mentioned in the previous post i am starting a seperate thread to discuss about my issue.I have attached the configs which was added for the ISDN to act as a backup link. Once again to make clear, the primary DSL...

Hi,i get an error message"copy tftp: flash:%Destination file system is read-only". while upgrading the IOS on my Cisco 2503 router, also when i verified the show flash it says READ ONLY, how to make it as READ/WRITE?

Hello,I have a 2620XM (12.2) with a T-1 and 1 LAN ports. I would like to provide a backup outbound connection via dsl or cable. I don't think the 2620XM can do the secondary external connection even if I got the additional LAN wic. I am not NATing on...

Have read cisco command reference, but still not able to understand commandsnmp-server engineID remote|localsnmp-server user snmp groupcan someone show the example?thanks