Routing

Hello there,i hae 2611XM router and 3750 switch that they are having problem and giving error upon booting.i've attached the errors in the file.please adviceregardsFady

Dear all,I would like to use autoinstall for download the router config from tftp server on another subnet. What is the initial config on the router (e.g. ip address and etc).Thanks.

Anyone have any experience in configuring G.703 multiflex forVoice/WAN? Bear with as this is my first time configuring an E1 G.703multiflex trunk. This will be an international link between 2 countries.My questions are what are the information do I n...

I try to configure a vpn between a pix and router 1710, but i have some error message. Error on pix:QM FSM error (P2 struct &0x18893c0, mess id 0x79263e2d)! [IKEv1] Removing peer from correlator table failed, no match!Show output:BALIPIX001# show cry...

I have a Dailer interface with two BRIs that belong to it. I use the BRIs to backup a frame relay circuit. I have to support up to 256k of bandwidth so i needed four bearer channels. I recently had a problem with the ISDN line that is BRI1/1. I n...

Hi,I have a cisco 1721 router along with an ADSL WIC (and ADSL line), which work fine.When one of the LAN user sends through ftp a large file to an external server, it renders every over external access sluggish (ssh, telnet, dns and even web browsin...

what configuration in the router would let the following display when you run "show running-config" ?!! Last configuration change at 01:12:23 UTC Thu Jun 15 2006! NVRAM config last updated at 16:35:55 UTC Wed Jun 14 2006!Thanks in advance.

I need a router recommendation for the following (I tried cisco's recommendation tool but it did not work?).8-10 Servers providing web hosting (www/email) services will be co-located.The datacenter is providing a 100Mbit Cat5e network drop.We need a ...

Host 172.30.208.30Router 172.30.208.1Router 172.30.7.1PIX inside 172.31.48.1PIX outside 60.200.200.2As noted above, I have a host with the IP addres of 172.30.208.30. I need this source address to change when this passes through my PIX to 172.31.48.3...

Greetings. I have a quick question that I haven't been able to answer in a CCO article:When you have an OSPF ABR, and you configure it with the default-information originate command (without the "always" option) will that ABR stop injecting the defau...

1721 router, IOS 12.2(15)T17.When applying ip nbar, we see citrix traffic classified correctly. When we install the citrix.pdlm, all citrix traffic now gets classified as unknown, but will not show up under ip nbar unclassified. We want to be able to...

switch is booting properly and SFP module is working fine i can able to reach the switch from SFP port but PoE 12 ports are not working in this module waht could be problem

Hi,I have following design question: If i have two NSSA ABR's and both are injecting a default route to the NSSA area, which route will win? Is the election of the default route inside the NSSA are based on costs too?Thanks,Robert