Well, I'm trying to make a tunnel between a WiFi hotspot ADSL router and another cisco router. I try to open the tunnel but I receive "% Connection refused by remote host" Below is my config, where have I gone wrong? ------------------------------...
I have one router with multiple ethernet interfaces connected to two different ISPs. I'm using route-map for PBR and for dynamic NAT. IOS version I'm using is 12.4 advanced enterprise. Internet redundancy is not working. PBR makes the switching of IS...
Hi all,Observed on 2621XM with 12.4.7 Advanced Security IOS.Configured p-t-p GRE tunnel (path-mtu-discovery enabled) via SP network using DSL technology over the last mile.Router receives (and accepts) ICMP unreachables 4/3 from next hop DSL router ...
I want to use my home PC to connect to my telco's ATM network which provides TV and Internet. Normally I would use a settop box which has an ATM modem. My PC has a normal ethernet NIC and I'm not sure if I can use that or if I need a proper ATM ada...
I have a Cisco 837 with version 12.2. When I try to boot it goes in Rom Monitor mode. I tried copy new IOS through "tftpdnld" utility which starts downloading IOS from TFTP server but terminates after a while, during this process a Warning shows at c...
My Fluke Optiview Wan analyzer keeps sending me this error..."Description: DS3/E3 Alarms detected: DS3 DTE Alarms exceed threshold : 1 contiguous alarm seconds (threshold=1)" . This is on a Frame Relay line on one of my WAN Routers. I've done the ...
I have a Cisco 877, with IOS 12.3(8).The router has been working fine for months, but the last two days every few minutes I see this type of entry in my logs, and Internet connection with ADSL is lost:000031: *Apr 6 09:29:46.663 BST: %LINK-3-UPDOWN:...
Hi, we have a number of sites connected over ADSL with Cisco 837s at each site.I would like to determine the speed of connection we typically get at each site. Is there any way to get a good indication from the Cisco 837 itself?I've run the command ...
I have a brand new 3005 concentrator and for some reason the WAN connection will stay up for only a limited time then it goes out. If I disable the card and then re-enable the card it works again for a while(aprox. 1hr). Are there any known issues ...
Using VPN on DSL, with GRE tunnels, I find on 1/2 of the routers I cannot telnet through the router - even with the same config. It stops cold, while others pass telnet fine. What's the answer folks?? Jeff
Which of the following is an OSPF configuration parameter that is used on an ABR, butnot on an internal router?A. A virtual link to area 0.B. OSPF summarization command.C. default-cost extension to the area command.D. no-summary extension to the area...
