Cisco docs state for cb-policing...Defaults: Bc = cir/32, Be = Bc (burst disabled).Recommended: Bc=cir x 1.5, Be = Bc x 2 1. For both CAR and CB-Policing is it true that...If Bc = Be, excess burst is disabled. Be must be greater than Bc for excess...
folksi have hp servers with teamed cards and they appear to be fault tolerant rather than load-balancei'm intent on trying etherchannels on 4 ports as i asume they do load-balancethe switch is a 4506 and the commands, i think arechannel-group 5 mode ...
Hi,I am searching some information for doing with an 800 router a practical fonctionality provided with the Linksys router family.Simply relay DNS request from the inside interface IP to the binded name-servers provide by the ISP on the outside inter...
Hiwe are going to be peering with an ISP, and they want us to take the Full BGP internet routing table,I am going to be using two Cat6500 for this that also server other puroposes in routing in my private networks,what is the best way to keep the bgp...
Dear AllWhat i know is if you there is 2 routers established EBGP via loopback address and the command {neighbor ip-address ebgp-multihop} used without speciying any ttl value in the ebgp-multihop command it's gone working because the default value i...
we have several routers that are looging th e following errors.*Mar 5 19:05:07.219: ILMI(ATM3/0): Sending ilmiColdStart trap*Mar 5 19:05:07.219: ILMI(ATM3/0): No ILMI VC found*Mar 5 19:05:07.219: ILMI: Encapsulation error on o/g ILMI Pdu <ilmi_send_p...
I am trying to configure it as the ISDN switch, and route calls for two Cisco routers, but I couldn't get it working. I am hoping someone here has been worked with one of the AccessSwitch...I can see the Layer 1 and 2 are up, but the layer 3 won't wo...
HiIf i would like to setup isdn peer-to-peer on the both side . I have to use command "dialer remote-name" on the both router each side ? or use on the callin router Thanks
We are an ISP, we are trying to connect to a new International ISP. The transmission between our 7606 router and one drop point is STM4 POS, and from the drop point to the International ISP is STM1 POS. The transmission guys told us it’s OK to make S...
hi all,I know that the router or bandwidth management tool like packeter definitely can do traffic prioritization over internet. but for firewall, I not sure, that's say, both site using Cisco Pix 506, currenlty, using site to site VPN, can both fir...
hi, I want to connect one small office to branch office with 2611XM. I want these provisions: channelized E1, isdn BRI port, IPSec vpn support, 1 fast ethernet port. are these supported on 2611XM at a time.Regardsskrao
hi, what i know is 7204VXR will not support supervisor engines. It will support only NPE. I am using only one chassis, so I want provide redundancy on 7204VXR. Does it support?Regardsskrao
