Routing

In the show ip cache flow output the packet counter for each source/destination pair some times has a K after it.For exampleGi0/1.1 192.168.5.85 Gi0/0 10.200.5.243 06 0050 E903 10KSince the counter is Packets does that K mean 10...

Hi everybody,I've some problem with a cisco 876. I've configured this device and I can access internet but only http site. when I try to access https site, I've an error in the explorer.... I've a second problem : I've a internal mail server. It send...

I have a T1 Point to Point between my main office and remote office. We have been having sporadic connectivity issues and had our provider check into it. They said they are seeing a lot of frame slips on the line and that we needed to setup our route...

the alert LED is on and i cant access the GUI. i tried to refresh my IE but the CE500 switch doesnt give me access to the GUI. tried connecting it to a 2950 and access. the show cdp neig cmd, only sees the CE500 but it dosent have a mangement IP. tri...

Can I configure a router of satellite site of a remote site that has a point-to-point connection with it, to join to the main DMVPN domain?

Hi alliam designing some network in my site, before that i want ask you some question about decreasing or hiding hopsmy network looks like belowInternet + +Core Router + +Switch with VLAN + + +Router with QOS / Firewall + +Customer edge Rout...

hi,how can we erease the flash memory in rommon mode, for new ios.Thanks

I have a configuration where I am doing BGP peering two different service providers and using HSRP to control outbound failover. One of the service providers (SAVVIS) recently installed two additional T1 interfaces into my router that connects me to...

Hii want upload the IOS of As5300 through Xmodem, but getting errorat HyperTerminal that "remote system is not responding" i have same baud rate on Pc a well as on As5300. and on As5300"mage size exceeds free flash space" I have tried to eraes flash ...

I have a Cisco 2600 series router in my lab...It's a modular router...Right now I have only 1 ethernet port on it (which is on board) I want to increase the number of ethernet ports. Probably I would be going with a expansion card for ethernet.Could ...

Can some one recommend an internet facing device that could provide the following.Qos and deep packet inspection filtering.I'm not looking for a firewall piece of equipment just a dedicated appliance that internet traffic flows through that is specif...

Hi, in my Set up i have a 3620 Cisco router.8 branch offices are connected to this router.and i have 5 Vlans are connected to this, i mean using subinterfaces in Fa0/0.Vlan Users are working fine there is no problem at all.but if i see the wan interf...

I setup my router to log to a server using the command 'logging 10.87.183.20'. Where is that log located once it is on the server?