Routing

Hi, I have a site with three distinct departments that need to traverse two different PVCs on the same choked DS3. They teminate at a 3745 with 4 ethernet interfaces, dept. A (WIRE) uses f0/0 and f0/1 (one for backup) dept B (BRANCH) and C (IMAGE) us...

Hello,one of my customer encounters a problem with a 7606 in version c6sup22-jk2sv-mz.121-26.E4.bin.When he changes the encapsulation ( ppp to hdlc or hdlc to ppp ) on his serial interface the service-policy configuration is removed.Exemple :xxxx02#s...

Hi I have 3725 router. due to insufficient flash i would like to boot the router using tftp. I want to know command to proceed. will i be able to download 64 mb file into memory.

I am in a process of upgrading a remote location from a T1 to ds3, my initial thought was to install a 3660 for the ds3. But wanted to some other remote end series router which is going to be suitable for ds3.Any help would be appreciated.

hi!Dear allI have implement a route-map in my bgp configration to set community attribute of the routes that will advertise to a eBGP peer.but it doesn't works : "show ip bgp community no-export" show nothing from the eBGP peer;below is my configrati...

I have PIX behind a router with 2 WAN interfaces. Main interface is for traffic and it fail over if it goes down. I have PBR enabled for traffic from the PIX, it fails over great. In order to allow remote IPSEC sessions I have two static translati...

hello, my question is the following, I have a cisco 2600 router connected to a T1 line and a 30 Mbps cablemodem line, I want the cablemodem as my primary connection and the T1 as my backup connection, when the cablemodem goes down, I want the T1 up a...

Can i enable CDP on Cisco PIX ?regds,aman

Hi Folks,I'm totally new to Cisco Technology, so I don't have a clue! That said, I'm hoping that someone in here might be able to help me with a problem I am having.I have recently acquired a 2621XM router, no software, just the router (cables are no...

I want to disable show CDP neighbours on privilege level 1.Is it possible or not ? If yes, what is the command for the same .regds,aman

Hi ,I have alots of drops on my backbone router. DS3 & E3 interfaces. DS3 - Total output drops: 6230.E3 -Total output drops: 13419105.How i manage them to reduce the number of Drops.Thanks.

Hi,This is Keshav from Bangalore. What type of WIC Interface to be used to support a High Bandwidth link (50 MB per link) on a 7206 Router for a IP VPN connectivity.