Routing

I have not been able to dial to a specific remote location from my central location. This is the only site where I am not able to dial, all other locations work fine.Attched is config and debug.File named "CE" is from central router and file "CODO" i...

Hi everyoneim building a solution for saving cost in cellular calls. For this, i have several GSM gateways (converts incoming calls in VoIP into GSM cellular calls)each GSM gateway has a different IP number and can manage up to 30 simultaneous calls ...

Hi Can 3640 Router be configured with NM-1E2W and VWIC-2MFT-G703 Card.?regardsR.Sundara Rajan

Hi,if we have two switches configured as vtp server which one will be active vtp server.is it possible to configure like primary and secondary vtp server with priority as is case for STP?Thanx&Regards,Rajesh

HiI have a cisco 4000 series here.It has 2 ethernet cards which i would need to configure 2 different network address on the 2 cards. e.g 210.24.x.y 255.255.255.0 and 192.168.x.y 255.255.255.0.Then i would need connect 2 pcs via cross cables to the 2...

We need to be able to ACCEPT REMOTE ASSISTANCE REQUESTS (EXPERT) trough our C871W from our clients that may or may not have an UPnP (Universal Plug and Play) compliant security device as they SEND REMOTE ASSISTANCE REQUESTS (NOVICE).It is imperative...

Hi,I am designing a redundant WAN environment and i just wanted to get some ideas on configuring HSRP between PE and CE. Customer has a single 20Mbs service to our core SOUL Australia. I want to get a clear picture on how HSRP works. I have attached ...

Hi,This thread is based on the configuration shown below. I have a 1721 connected to SBC via PPPOE. I'm using the router as the PPPOE client and have configured FE0 as the gateway and set up DHCP.When I plug my laptop into FE0 I get an IP address. I ...

I've got an old 2503 router with onboard serial port that I am currently running a 128K Frame circuit on. We need to upgrade to T1 and my ISP is telling me I have to increase the timeslots to support T1. Problem is I do not have a 'timeslots' command...

I have a requirement to have EIGRP provide dynamic routing to a VIP. I have an HSRP pair running HA IPSec. My IPSec routers are redistributing static routes into EIGRP. packets are routed to my standby router and therefore do not get encrypted and as...

we are ready to start an MPLS migration from frame. We will have a 12MB DS3 circuit here at HQ. I was ready to place an order for a 3825 when the IT guys at one of our sites was told by a Cisco re-seller that if we go to a full DS3 a 3825 won't handl...

In my setup i have 6509 switch is connected to Alteoan AD-4 load baalnce.Alteaon AD 4 is having 100 MBPS link.This link is utlized around 95 % (95 MBPS).so packet drop is observed on this link.On Alteoan AD-4 i need to combine two link as in cisco...

Hello.I Want to configure my 2600 router to work as a router to my ADSL connection Via PPPoE.i have a (Modem/Router) given to me by my ISP but it doesnt stand up to my requirements. i have found in sevral places on the internet configurations for thi...