Routing

HICan I continious ping from router like windows machine ?. like 192.168.10.1 -tThaksBiplob

In one of our offices we have a DSL router connected to our Pix. We are implementing a T1 and I configed the router. The T1 is connected to the router and I can get in. But when we go to connect the router to the pix the link lights don't come on a...

Hi!I have the following Pix 506 Firewall, that has been working good for a few years. But suddenly, the Pix stop booting up. The only thing that is happening is the network traffic led flashes and the fan that moves everytime the network led flashe...

I have an HA IPSec router pair that has HSRP between them. In a normal senario when a link fails it causes the router to reload. I would like to delay the reload up to 5 seconds after a link failure to prevent erronious reloads.does anyone know if th...

1721 router with 128M Dram , 32M Flash , c1700-advsecurityk9-mz.124-4.T1.bin ios file, when MOD1700-VPN inserted , the router will go into Rom Monitor mode ,here is the message of console:System Bootstrap, Version 12.2(7r)XM2, RELEASE SOFTWARE (fc1)...

Hi all,i try to get connected a Cisco 3500 Switch and a HP Procurve 5300 Switch via 1000base sx. On the Cisco i have a GBIC 1000base sx and on the HP i have a SFP 1000base sx modul. Both Switches are cabled directly with an 50/125 cable. When the con...

I have a Client server with a 142.x.x.x IP which is natted onto the Router Fastethernet interface to 172.x.x.x IP. If I do a ping to the 172.x.x.x IP to check the connectivity between the Router and the destination server, will that show me the corre...

I have an router AS5300 and need IOS for enable ipv6 to router and where can i download the IOSthanks

I have 2 loopback interface configured on the router: int loopback0ip address 10.33.32.1 255.255.224.0int loopback1ip address 10.33.64.1 255.255.224.0And I also put it into the OSPF process:router ospf 7network 10.33.32.0 0.0.31.255 area 3network 10....

We currently use BGP to peer with our MPLS provider. In one of our areas we have two routers that peer to different provider #routers. Within our area we run EIGRP and the two routers have all routes for the area. The routers do not use IBGP. What we...

Hello everyone,I have a problem with an 3640 Cisco router which has the following IOS : c3640-jk9s-mz.123- 10.bin.On the router is enable an nat translation with the following command : ip nat inside source static ip_number_x ip_number_x route-ma...

Hi, After rebooting a 7507 with one RSP8 installed , system didn't come up and no console messages are displayed on hyper terminal. Normal LED is green, both Master and Slave LEDs are on. I have only one RSP4 as spare in hand. What can i do to see wh...

I need to filter ICMP Timestamp requests at our outer router. Is it as simple as adding this to our ACL? deny udp/tcp any any eq ports 13 and 14