I'm new to OSPF and EIGRP, and I've been given questions for it.
Forum Posts
I have a customer, who uses the same BGP AS for all of their sites(AS 65002). These sites only peer with the ISP MPLS(AS 65001). How does the ISP AS 65001, advertise routes learned from all the peers, to each other? I'm trying to replicate it in my ...
Hi All I have routers connected from one site to another using OSPF over a tunnel.I have configured new tunnels using EBGP by manipulating the local-asA lot of my subnets have gone over to the new BGP tunnels as they have an admin of 20 vs 110 Howeve...
I have one Cisco 2911 router running IOS version 15.2(4)M2. I am running BGP and need to build a BGP neighbor relationship with 2 different cloud providers. Is it possible to use one BGP AS and neighbor with 2 different AS? IF the answer is yes, can ...
How often do ports have a default port priority?
Hello to alldo you think it is possible to configure BGP confederation and also configure the RR for each sub-autonomous systems?
We are a company with over 1000 users and we have a /23 public IP and a 200Mbps leased line connection. which is the cheap and best cisco router for BGP configuration between our subnet and the ISP.
I know that in order for host 1 to receive it's IP config from the DHCP server, the command 'ip helper-address 10.1.1.1' would need to be applied to the Fa0/1 interface. Is this true?
How many network commands would be needed to connect 4 routers?
Hello All I am studying for the CCNA just to give you an idea of my current knowledge level. What I know:S0/0/0 = Serial: Module Slot 0 / Interface Card Slot 0 / Port 0 What I am confused on:When you see S0 or S0/0 - which slots are removable and whi...
Resolved! ebgp config not advertising prefixes
I am having issue with eBgp configuration and will appreciate your feedback and guidance. BGP is active, but i am not learning route or advertising prefixes. the upstream ISP are not learning prefixes from my end. i have advertised my network, yet st...
Ok, I have a weird issue going on and it frankly has my coworkers and I stumped. From any host computer on our network we can ping a specific IP address that is outside our network but when we try to do it from our router, it doesn't work. This is ...
Could this IP be the next hop address?(image not available)
The command that produced this output was Show monitor session 1 detail and session 1 shows that the switch will copy packets entering port 5 and send the copy to port 10. Why?
Resolved! Configuration issue with IPsec
Hi all, I am having a hard time with IPSec config, I set it up and when I enter the command on the tunnel interface, tunnel goes down right away. This is the error message : %CRYPTO-6-ISAKMP_ON_OFF: ISAKMP is ON LINEPROTO-5-UPDOWN: Line protocol on I...
