Routing

Hi, Everybody!AIM Modules use IP Payload compression protocol ( rfc 2393 ), but I cannot find Which compression algorithms can be used with AIM Modules for 1841?How helpfull could it be while using 2 Mbps WAN connection?Thank you!

Hi,I have the following configuration below:access-list 100 permit udp any any range 16384 32767access-list 100 permit tcp any any eq 1720!route-map classify_markmatch ip address 100set ip precedence 5!interface Ethernet0/0ip address 10.10.10.1 255.2...

I have just recently buildt a lab for the group that I work with. I used an old AGS+ as the frame relay switch. I wanted to upgrade the IOS to the latest that it can run but am unable to find release 11.0 in the software download section of cisco's...

I have a customer who we are slowly moving off ATM to private fiber. I recently converted one link and can not ping from that router to other routers that are still on ATM. If I do an extended ping from any interface I can ping. The network is runnin...

Scenario:1601R connected with an ethernet crossover cable to a 2612.Both devices have ethernet (10Mbit) ports.I've set the ports up manually on both sides using the command "duplex full".The speed command is not available as (I guess) these ports wor...

Hi everybody,I want to implement QoS on my DSL-routers, with both an ingress and egress-policy.I want to be able to give a minimum bandwidth to certain protocols and still have the possibility to have those protocols use up to full bandwidth if avail...

Hi,we have a group of routers all running OSPF process for routing. We plan to move to EIGRP as OSPF is not supporting load balancing. If we seperate network in two different parts as one with OSPF process and one with EIGRP process. And then redist...

I have 2 adsl modems. i wish to connect (using 2 interface dialers) to the internet with them both and use load-balancing.The first dialer connects with no problem but it appears that the second dialer never dials.any did this before?(i added a file ...

Have read ciso documentation many times but still not able to understand the command "default-information". Can someone show me the example?many thanks

I have a T1 at our main location all is good there. now we are expanding and I ordered a new t1 for new remote location. 1) can I create a VPN tunnel between the two routers? 2) If yes then how will I get to internet? will it still go through my orig...

I have not been able to dial to a specific remote location from my central location. This is the only site where I am not able to dial, all other locations work fine.Attched is config and debug.File named "CE" is from central router and file "CODO" i...

Hi everyoneim building a solution for saving cost in cellular calls. For this, i have several GSM gateways (converts incoming calls in VoIP into GSM cellular calls)each GSM gateway has a different IP number and can manage up to 30 simultaneous calls ...

Hi Can 3640 Router be configured with NM-1E2W and VWIC-2MFT-G703 Card.?regardsR.Sundara Rajan

Hi,if we have two switches configured as vtp server which one will be active vtp server.is it possible to configure like primary and secondary vtp server with priority as is case for STP?Thanx&Regards,Rajesh