Routing

I set the Date and Time on my router and then as soon as I reload, or power off and on, it comes back saying 16:00 PST Feb 28 1993. Any suggestions?

I have a 3725 with two two port T1 WIC's in W0 and W1. In W2 I have a T1-CSU/DSU-T1-V2 WIC. I am recieving a cd green light and an alarm light. The serial interface 0/4 is showing down and down. I want to confirm a correct configuration. Current...

Does anyone have experience with the following situation?Deploying bi-directional VSAT communication with the use of OSPF. My question in this particular case is how OSPF should be configured. Fact is that I do not know if this VSAT can be compared w...

Hi there,I am very new to cisco networking and have just been configuring the gateways on a couple of routers either end of a leased line (between corporate and the remote site). At our corporate office we have another router that goes out to the int...

When the the ISDN interface BRI0/0 is not on call the router shows "BRI0/0 is up (spoofing), line protocol is up (spoofing)".I know this is needed for IP to see the interface viable.But when the call is estabilished and the router says "BRI0/0 is up,...

The unit for bandwidth is kilobits/secWhen I checked that for policy-map it is in kilobits/sec, but when I checked the serial interface it was not,,,any hint about this ?Router(config-pmap-c)#bandwidth ? <8-2000000> Kilo Bits per second percent ...

Dear All,we have a cisco 3745 equipped with "1-port OC-3 ATM Enhanced perf Single mode Long NM 3" Module , do the specification of this midule match the G. 957 Standard ?second question : is it possible to connect this module to single mode mode ...

Dear all,Is any one having documentation about how to design Flexwan module for ATM.My requirement is that now i hv one 6509 Switch which having FlexWaN module on which we will terminate STM in which we give Bandwidth to all customer thr' that Pipe ...

I have classic situation, router, two interfaces, two ranges A on outside and B on inside, defined some translations and it all works ok. But I have one IP I'd like to be accesses from outside without NAT. I've made translation entry from B3 to B3 an...

HICan I continious ping from router like windows machine ?. like 192.168.10.1 -tThaksBiplob

In one of our offices we have a DSL router connected to our Pix. We are implementing a T1 and I configed the router. The T1 is connected to the router and I can get in. But when we go to connect the router to the pix the link lights don't come on a...

Hi!I have the following Pix 506 Firewall, that has been working good for a few years. But suddenly, the Pix stop booting up. The only thing that is happening is the network traffic led flashes and the fan that moves everytime the network led flashe...