Routing

Hi alltwo routers are connected via two serial port R1=====R2i configured both the serial port s0 and s1 with ip add 192.168.1.1/24 on R1 and ip add 192.168.1.2/24 on R2. It was working and load balancing was also working.can somebody guess what is h...

dir Sir:i have two routers , and i enable the bgp using ibgp (internal) and the both are connected by ethernet, and have the following configuration:Router 1:router bgp XXX no synchronization bgp log-neighbor-changes neighbor 192.168.209.1 remote-as ...

Hello All. I have two sites, each with a 3640 running version 12.1. I have three T1's between the two sites. I want to load balance the three T's. I was looking at Multilink PPP, but our lines are bouncing when using PPP for encapsulation. We...

I 'm configuraing pix firewall 515, version 6.3i want rip to advertise the direct connected route to its neighbor.How can perform it ?Any suggest will be appreciate.Best regards.

Hello,i am searching for an particular ios command to set an serial interface to down if the router recognize that the line is flapping or that the line has errors (e.g crc).Is there a tracking command for the line or something else ?Thanks for all r...

Does someone know the most common ISDN Signaling Type for E1 used in Mexico. I am not getting any help from Telco at Mexico.Regards,

Dear The Expert,I am very new with this, everyday my connection between HeadOffice and Branch B working properly, I dont understand whats going on today, I got problem that make me confusing, all of users on branch B (172.16.6.x) cannot ping toany PC...

I have an issue with VPN connections being dropped when I have CEF enable, while using GLBP. I'm assuming that as connections are load balanced between the gateways by the active GLBP router, and that the client GLBP router doesn't see the right CEF...

I am having a lab with a problemIn the lab there are two LANs (LAN1 and LAN2) connected via 2 WAN routers (3745A).Between the routers there are a simulated (Line simulator) 6 Mbit connection.Between the two LANs, there are also attached a packet gene...

I have 2 IPv4 subnets which are connected to each other via an IPv6 network. For several reasons I don't want to go into here it's better for me to use NAT-PT at the two v4/v6 boundaries instead of creating a v4 tunnel over v6 network.The result is t...

Hi,I'm using traffic policing to restrict up- and downstream bandwidth, with a config like:class-map match-all EVERYTHING match any!policy-map IN class EVERYTHING police 192000 36000 72000 conform-action transmit exceed-action transmit violate-actio...

We know that there are 4 classes for AF, AF1,AF2,AF3, and AFf. and for each class there is 3 Drop Probabilities. AF technique quarantees bandwidth for specific class and maybe use extra bandwidth if available. i have a question, AF4 has better teatme...