Routing

Hello,I was told by a co-worker that Cisco makes IOS downloads available for no charge if the device is no longer supported or has reached the so-called end of life. I have a 2514 that I got from EBAY. It has IOS v11.2(10a), as seen below in the ou...

Appreciate if someone has a few minutes to make the test, just paste the following lines:access-list 10 permit anyroute-map TEST permit 10 match ip address 10 set tag 100And then issue sh run. My problem is that the set statement does not appear in t...

Hi..I have 4 IPLC's on my router.I want to send traffic from 172.30.1.x on 10.10.14.x(voice)backup 10.10.12.xFrom 172.30.3.x on 10.10.12.x(data).bachup 10.10.10.x10.10.20.x is used for other trafficcan i employ something other than route maps ???I ha...

Hello,Newbie question. How do I completely clear/delete the current running-configuration on a 2514? I want to start the router config totally from scratch.TIA,Rich

Hi; Does any oen know where i can find some documentation on configuring a VACL of a 3700 series switch?

I have one primary and one secondary OC3 at my hub along with full T1's and DS3 connections at my remote sites. At my hub site I currently have two 6509’s with pos cards in them running a sup-720. I currently have 83 PVC's hanging off my one OC3 inte...

I would like to know how do we install and configure g.703 card on 2600 router.After installation can we check whether the configuration is correct.Regards,Mustafa SFI

I have an issue where routes known via OSPF are not being put into the routing table.Two routes are known to a remote LAN both have admin distance of 110, the first has a metric of 2048 the second a metric of 6000 but the second is put into the routi...

crash info:C2950 Software (C2950-I6Q4L2-M), Version 12.1(14)EA1a, RELEASE SOFTWARE (fc1)Compiled Tue 02-Sep-03 03:33 by antoninoSignal = 10, Code = 0x8, Uptime 28w0dr0: 00000000, AT: 00000000, v0: 00000000, v1: 80D581C0a0: 00000006, a1: 00000000, a2:...

Hi,Can I configure multilink on serial links with different bandwidths? I am made to understand that multilink does a per frame load balancing irrespective of the link size and this may chock the lower bandwidth link and drop further packets routed t...

Hi all,I'm trying to set up some policy based routing; my route-maps match on an ACL and do a "set interface".If my acl says this:permit ip source.addr source.mask any...PBR works as expected. However, if it says this:permit ip any dest.addr dest.mas...

Currently we have a setup of link between HO and remote branch.HO is connected via leased line with v.35 interface.Remote site is connected through G.703 card to the router.We have done basic configuration, and still the link is down.We need to find ...