Routing

We have removed a software from flash memory, and replace it by a new software.And we have format bootflash memory and replace it by a new sofware.The UBR7246 can't load memory normally, we have some error while booting:System Bootstrap, Version 11.1...

I currently have two 3745 Routers that I would like to take the built in fast ethernet interfaces and configure them for etherchannel. I have run into a problem however. I can create the port-channel interface and I can also add the fast ethernet int...

Hi.We have installed an E1 line that would connect remote ofiices to the central site. The telco has told me that only two of the channels has been activated.The telco only provides physical layer transmission.thanks How would you configure each chan...

Hi, we have a setup which is having Ethernet Modems which is connected to 20 different locations all are on the same network(192.168.1.0/24). in each location max. 2 PC's are connected, now when all the ppl. are trying to send the file from various ...

Please help me to recover MGX 8830 password, I try to find the method but I just found only for the router and catalyst switch.

Hey guys,I have a site with a Cisco 1720 running 12.2(4)T3. They have a T1, 12 channels for voice, the other 12 for data (768kbps). I need to set them up to guarantee 2x44kbps bandwidth for two VoIP lines that always terminate to 66.239.20.0/24. The ...

Hi, currently i am facing a probs in WAN connection, PC A(170.1.97.27/24) is connected to PC B(170.1.97.51/24) via RAD Ethernet Modem( 1 modem in PC A & other in PC B side) PC B(170.1.97.51/24) is connected on Switch A(located in 2nd Floor) Sw...

Is it possible to disable the onboard RAM and just use the add on RAM?

System:2651XM 64F/256R with NM-16-ESW, WIC-1T.The Router are calculating the EIGRP Delay wrong. This is the same machine, we tested both IOS versions. No changes to the config are performed. Is this a known bug ?Software 12.4.1a IP-EIGRP (AS 1): Top...

Hi, Need some reassurance I'm on the right track. We just switched our ATM PVCs over to a 7507 using a PA-A3-T3 card and running in a VIP4-80 and dual RSP4 processors. We upgraded the circuit from a full T-1 to a fractional T3 running at 25meg. ...

Hi,I have a "Cisco Small Form-Factor Pluggable Gigabit Interface Converter(LC Connector)" and "Cisco Gigabit Interface Converter(SC Connector)" with me. I have only SC - SC Fiber patch cord and LIU with SC Connectors with me. Will i be able to connec...

What would be the best QOS method to use in the following situation, and where to place the policy - i.e. hub, spoke or both:Main site = DS3 (ATM)Remote sites = T1 (frame relay)Need to ensure that client (remote) sessions with server (main site) get ...

Hello Guys,I want to know that WIC-1ENET Ethernet Card is supported by 2651-XM router without any Network Module.2651-XM have 2 Ethernet Ports. I want to have 4 Ethernet ports so if i install 2 WIC-1ENET Ethernet Card to the free WAN slots, will it w...