Routing

Host is trying to get to 3.75.72.1.If the router has a choice between 3.75.0.0/16 as an external BGP route and 3.75.72.0 as an internal BGP router - which is chosen?

HiWhen we face a problem about Switch or Router and would like to solve the problem TAC support they want to observer show tech. But how come we understand where the problem after showing show tech. I would like to be familiar with detail show tech. ...

Hi all,I got a used 7206 router, but without any IOS inside, nothing on bootflash(4M), nothing on Flash(20M), how do upload the boot image and IOS ?any input appreciated.Thanks

Dear sirsWe have Cisco router 75xx series with the following data IOS (TM) RSP Software (RSP-ISV-M, Version 12.2(2) T1 ROM: System Bootstrap, Version 11.1BootFlash: GS Software (RSP-BOOT-M), Version 11.1(22)Cisco RSP2 (R4700) processor with 65536K/2...

All,I would like to test the network traffic for the Gigabit port.Could anyone let me know if there any softwares which can be used to check the traffic (apart from Smartbit Tester)Thanks a lot

I had upgraded several Cisco 1003 on a customer site to the actual IOS. By mistake I did not notice that one of them had only 4MB DRAM. Now that one is not operational any longer. We just need the router to dial to an Internet provider and nothing el...

Hi,How load balancing performed in ISIS with 7 routers with same multi-area 1-7? Any idea or URL would be highly appreciated.Best Regards

Is it possible to enable the ethernet 2 interface on 836/837 like on the 830 to use as a DMZ interface ?

Can you give me examples of different Cisco 828 configurations?thxRichard

Hi,I have a little oddball of a problem.I'm trying to enable ip cef on a 1720 running 12.05Tbut it doesnt recognize the command from global config.Anybody got any ideas

I configured netflow on 6509 MSFC, but it is showing only broadcast Reason ?ThanksPradeep

Our organization is currently using 144.x.x.x network as our internal ip addressing scheme. internal users connects to the internet via proxy. the proxy's default route is to go internet. internal routes are defined statically. our issue is, if i...

my router's serial interface s0/0 is connected to ISP with 256k duplex. I want to limit the outgoing(browsing)traffic to 32 kb and allow incomimng 256k full in my cisco2611 ruoter.how can I set it? please send config for it.thanks in advance for help...