Routing

We have a hub & spoke frame-relay WAN with 5 remote sites. Once we turned up all of the frame circuits, we advised the customer that they are ready to use the routed frame connection. Long story short is that the customer wants a bridged connectio...

Hi all,Reading through the 'BGP Case Studies 1' on CCO, I came across an example under the section 'Static Routes and Redistribution'. In the example right after the first diagram in this section, it states that: "Note that you do not need network ...

I would like to know if I can use a Cisco 827 ASDL router and a 1720 router to study for the CCNA test. I have to use an ASDL for one router, because I have DSL. From what I hear you need at least 2 routers, and I may have to mix and match whatever...

Is there anyone using the Wan Compression Modules for the 26XX/37XX and the 72XX. If so just interested in seeing how the performance works.

can’t understand how to calculate Normal Burst and extended burst from the formula: normal burst = configured rate * (1 byte)/(8 bits) * 1.5 seconds extended burst = 2 * normal burst" That’s what I did, If some one can help me that I am doing it corr...

Hi,I am using 2 ISP's to connect my network with internet.i have put routes like..0.0.0.0 0.0.0.0 isp1 next hop ip0.0.0.0 0.0.0.0 isp2 next hop ip 50The problem is..When my isp1 is down..then i am not able to access router from my home..there is no a...

Hi, i´m installing a router 3810 with to serials interfaces which are using a point to point frame relay circuits each one, my routing protocol is RIP and i will change to Eigrp 10, anyone know how can control that only the HTTP traficc acrooss to t...

I would like to learn how to setup a network using a Cisco router, firewall, and switch. I would like to know what anyone thinks about using a Cisco 827 ASDL router,a PIX 506e Firewall, and a Catalyst 2950 switch to get some hands on experience. I ...

Hi all,I am trying to configure a GRE tunnel between a 2651 Router and a Satellite Equipment which supports this Protocol thru satellite link. First of all, what i could observe is that my tunnel is established, bcos when i trace from my PC connected...

Hi,Looking for sample configuration for router.I want to block workstation mac-address to access network resources."Extended Access-List"RegardsMeer

I would like to create an EIGRP neighbor relationship between my inside router and my Internet router. There's a PIX firewall in between the two routers.Any idea if this is possible?Thanks in advance.

Hello all,I have a 3745 Router with IOS ver 12.3(7)T and I have another Router (2621 model ) which have a card with 10Base T/AUI port .Will this card work with 3745 Router with IOS 12.3 (7) .Thanks with regards,Raju

Hello, I have 2 main offices and several branches. Plz take a look network diagram in the attachment file. The Internet connection come through the HQ to Telco and Telco continue providing to others branches at the provices. The questio...

Dear All,Is it possible to traffic shape Frame Relay PVCs that are switched between interfaces.I have a router with Frame Relay PVCs that bother terminate on an interface and others taht are switched throughto another interface. We have shaped the PV...