Routing

This is a sort of generalised question. Someone has asked, and am actually scratching my head thinking that he has the wrong end of the stick entirely and I want to put him straight.The sceanrio is:we are going over to another ISP for our Internet/si...

We have a Main Campus and a Remote Site approx 400 meters apart.Previously the Remote Site was linked by a wireless connection and shared a common LAN with the Main Campus. Servers at the Main Campus provide DNS, DHCP, Email, Internet & data storage ...

HiI have configured QOS in Cisco 1841 router. I want to prioritisation of traffic such as voice and other data traffic such as vpn, citrix, mail, web etc. I will send you my router configuration below. I want to establish QOS so that each traffic sho...

After configuring multilink PPP when I start data transfer through my Cisco 1721 I am experiencing high latency. Prior to configuring multilink ppp there was no issue with latency. Could anyone help.??

I have a cisco 3725 router,used two ethernet interface connecting to different isp,I want to prefer one isp ,then another for backup,then I do ip route 0.0.0.0 0.0.0.0 x.x.x.x (isp1)ip route 0.0.0.0 0.0.0.0 y.y.y.y 100 (isp2)but because ethernet nati...

system forced crash errorsignal=0x17,code=0x42330000,context=0x42361084pc=0x4012daec,cause=0x1820,statuskey=0x34018002Iam getting this error in cisco 6509(supervisor engine 2).In the cisco 6509 switch the standby supervisor engine - 2GE is showing"un...

Hi,I've got a 2621 running 12.3 with the full ipsec set so I can run ADSL lines with IPSEC tunneling into our main offices. This is a standard branch office setup for us.The problem currently is with a new office needing 2 DSL lines because the upstr...

Hi,Our company is planning to purchase a couple of 7500 series routers to replace 3600 and 3800 routers currently in place, and also purchase some core switches (no model decided yet).My experience with Cisco has been on the low-medium range, from 80...

I have a situation where I'm trying to bring up three T1s across two VWIC-2MFT-T1-DI cards in built in WIC slots on a 2610. I can't get the serial int line protocol to ever come up, the MFR interface sees no LMI etc. But I can use two of the T1s on...

Hi All,I have 3548 switch in my network and i am on switch: prompt. trying to load the IOS threw XMODEM but getting following error.switch: copy xmodem: flash:c3500XL-c3h2s-mz-120.5.2-XU.binBegin the Xmodem or Xmodem-1K transfer now...CCCCCCCCCCBB0BB...

I have two main locations each with their own Internet connection. There is a Frame relay connection between the two main locations and a Frame relay connection to 6 remotes, a PVC to each main location. Right now static routes are configured in the...

can one configure virtual templates to dial out (adsl) instead of using a dialer int?thanks

Got a Router configured as a voice gateway for CCM with an E1. I've been trying to capture the number of open calls on the link and I've been seeing some wierd results. If I issue 'sh voice call' I see a list of the channels and it shows the channe...