Hi Folks, Based on Cisco documentation about NAT, the following ports are used during the overloading process. When configuring for PAT (overloading), what is the maximum number of translations that can be created per inside global IP address? A. P...
Hi,I'm having trouble setting up my network. I can't get the 2 points to communicate. Could anyone help?I have a point-to-point link with the other office, the machines communicate internally, and can reach the internal ASA vlan, but from there the...
VWIC3-2MFT-T1/E1I have one card on cisco 1921 and i need to configure this to interface with SDH using E1 and the other side i have one Router connected in Datacom modem. Router Cisco 1921 (VWIC3-2MFT-T1/E1) ===> SDH Hauwei <===========> SDH Hauwei ...
Hello all, I have a router in production ISR4331/K9 IOS-XE Version 16.6.2 that in the last month started to prompt these log messages: %PLATFORM-4-ELEMENT_WARNING: SIP1: smand: RP/0: Used Memory value 89% exceeds warning level 88% The show memor...
Hi, Thanks in advanced for your time. I am trying to configure a CSR1000v in AWS to have 2 customer side VRFs (VRF 70 and 71) and route based VPNs tied to each VRF. There is a remote gateway terminating the tunnels (it can handle the multi-vrf stuf...
Where can I get IOS 15.1-4.M12a for a 2811 and a 2821?
I have a RV345 running Firmware 1.0.03.20, it is intermittently restarting. I have turned on logging and I don't see any errors. I am trying to figure out why the router would reboot on its own. It happens 1 to 3 times a day. This has only become...
hi guysI have a lot of 4221 but faced the problem for the first timewhen entering the conf mod, the cisco turns off, helps to switch the power plug. At the moment, it has been taken out of use, the new cisco works stably. Debugging does not repeat th...
Hi We are using PPPoE termination on ASR1000 for years. We are considering to migrate to IPoE solution.(Using DHCP)1- I want to ask, Is there any benefit to do this?2- Is there any drawback in this case? 3- What is the the Big ISPs approach?about 15 ...
dot1q-tunnel is not working on N3K-C31108PC-V
I'm new to cisco networks (and network admin in general), so apologies in advance if I'm missing something simple.I have a 1921 router and a 2960-S switch that I'd like to connect a PC and to the internet (see diagram below). I've configured the rout...
Hi all, I have been trying to use one of the QSFP ports in an L3out on a 93108TC-EX, unfortunately, it doesn't seem possible in the APIC GUI and I'm currently guessing that these interfaces can only be used as spine uplinks looking at some of the Cis...
Hi guys,for a while i'm struggling with a project in packet tracer. Is there anyone who can help with this? These are the guidelines:Device and Vlan addressing tableImplementation of the DHCP serverVlan network implementationTrank implementation / Et...
Hi allI passed my CCNA exam on February 21, 2020, so far I did not have my certificate. How did I get my certifications?Regards, Dhanwin De Leon
