08-23-2013 12:17 AM - edited 03-04-2019 08:51 PM
Hi,
My LAB has three AS 100 ,200,300 ...I want to permit only AS 200 to R3(AS 300),but when I checked R8,R7 which are belong to AS 100 are also able to see inside networks of AS 300.
Please help me in this.
I attached config and diagram with this message.
Thanks,
Anand Solgama
Solved! Go to Solution.
08-23-2013 12:35 PM
If u can suggest me command will be great help
Thanks,
08-23-2013 12:43 PM
Anand,
If I understand you correctly , you do not want AS200 to become a transit AS between AS100 and AS300, right? You have already applied filtering on R3 to ensure that AS300 will not use AS200 as a transit AS to AS100. You now have to apply the same filtering on R8 for the bgp session to R9 to ensure AS200 does not become a transit AS to AS300.
Another way to address that without changing R3 and R8 would be to configure R9 to only advertise the local routes (^$) to both R3 and R8. This would have the same effect.
Regards
08-23-2013 12:50 PM
My previous comment about last question I typed before see ur last post So now I get it These two ways
one ---Config on R8
second----Config local as advertise on R9 thanks
Freind Thanks a lot for your great help ,I sent you request in linkedin too pls accept it I checked about you that you have
14 years of experience and you have CCIE ( R and S,SP) OMG!!!!
So,I believe on you about answers
08-23-2013 01:02 PM
You are very welcome Anand. Thanks for the kind words
08-23-2013 10:49 AM
Yes I always do cle ip bg * command to clear to make sure connection come with new settings
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide