cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
299
Views
0
Helpful
3
Replies

bgp issue urgent

John Blakley
VIP Alumni
VIP Alumni

I have a site that shares the same public block, and at that site I have a route map that sets a metric to higher than our current site. I'm trying to connect to the public side, but I randomnly get there and I know why.

The pertinent parts are:

int s0/1

ip address 6.6.6.1 255.255.255.252

access-list 10 permit 5.5.5.0 0.0.0.127

route-map ADV permit 5

match ip address 10

set metric 100

set community x:x

router bgp 5

network 6.6.6.0 mask 255.255.255.252

network 5.5.5.0 mask 255.255.255.128

neighbor 1.1.1.1 send-community

neighbor 1.1.1.1 route-map ADV out

The problem is that I have a Fatpipe that all of my links come into at my main site. The traffic outbound can go out any one of those links. I realize that when it goes over the second link, it's not allowing me to get to the router and I think it's my route map.

Should I also create:

route-map ADV permit 20

and leave it blank? I don't think the 6.6.6.0 subnet is getting advertised.

Thanks!

John

HTH, John *** Please rate all useful posts ***
1 Accepted Solution

Accepted Solutions

Edison Ortiz
Hall of Fame
Hall of Fame

It is not and your deduction is the correct one.

View solution in original post

3 Replies 3

Edison Ortiz
Hall of Fame
Hall of Fame

It is not and your deduction is the correct one.

Thanks Edison. I'll be fixing it tonight.

HTH, John *** Please rate all useful posts ***

Good luck. Routes not matching ACL 10 were being processed by the implicit deny on such route-map. That will always get you :)

Review Cisco Networking for a $25 gift card