so I’m pretty new and I just built a home lab, 2x 2811, 2x 2960, 2x 3560, 2x 1841, and an ASA 5505. The issue on having is the Voip phones fully configuring. The phones will boot and it will pull the right default gateway and it will show an IP from the DHCP pool on the phone, but it would just constantly say configuring IP. Someone told me that I need bin files for the phone to finish registering. I’m just not sure if those files are even supported anymore or where to even get them any help would be much appreciated.
Solved! Go to Solution.
That is the issue I have been running into since I went with a lower initial cost for my home lab. I found a internet archive site that has iOS files, do you know what a CME install file naming architecture would look like by chance?