04-19-2011 10:19 AM - edited 03-04-2019 12:07 PM
Hi,
Here is the current Cisco 877 configuration:
bridge irb
!
!
interface ATM0
no ip address
no ip mroute-cache
no atm ilmi-keepalive
dsl operating-mode auto
!
interface ATM0.1 point-to-point
no snmp trap link-status
pvc 0/40
encapsulation aal5snap
!
bridge-group 1
!
interface ATM0.2 point-to-point
no snmp trap link-status
pvc 0/41
encapsulation aal5snap
!
bridge-group 2
04-19-2011 10:40 AM
You missed
bridge 1 protocol vlan-bridge &
bridge 1 route ip
Regards
04-19-2011 10:50 AM
Hi Rama,
I had following lines configured that I forgot to copy:
bridge 1 protocol ieee
bridge 1 route ip
bridge 2 protocol ieee
bridge 2 route ip
04-19-2011 10:57 AM
Oops, I was looking at something else. The one I gave was for bridging a vlan and an ethernet port.
There is a way to bridge a FR PVC and Ethernet with the following command.
frame-relay map bridge
I will check if there is ATM substitute
Regards
04-19-2011 11:06 AM
Did you use
atm route-bridged ip
on the ATM sub-interface?
04-19-2011 11:26 AM
Yes, I tried it too.
Here the same problem was resolved by configuring CRB instead of IRB.
http://puck.nether.net/pipermail/cisco-bba/2008-April/001065.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide