Bridge from WIC interface to Ethernet Interface

[lcnorwood]

Needing to bridge from my wic interface to an ethernet interface on a 2900 series router so that I can pass through the ip address given to the WIC, to my ASA so that I don't have to give my ASA a private range address. (Just like a service provider might do when bringing a T1 with managed router in to my prem)

Any help would be most appreciated.

[lcnorwood]

After a little bit of further research, I realized this can be done by transparent bridging.

Set bridge-group on both interfaces I want to bridge against, and that takes care of everything.