C1941 POE, AP2802

[Maurizio Caloro]

Hello
Please i have here C1941 with POE-Supply and i try to apply AP2802, but i see that the POE
cant deliver enought power to bring the AP Up and running. no i dont want to apply any ACDC for AP.

actually a pity, available power supplies that would deliver more power for this setup?

--

Router#sh int status
Port Name Status Vlan Duplex Speed Type
Gi0/1/7 connected 1 a-full a-1000 10/100BaseTX/1000BaseT

Router#sh power inline
PowerSupply SlotNum. Maximum Allocated Status
----------- -------- ------- --------- ------
INT-PS 0 80.000 15.400 PS GOOD
Interface Config Device Powered PowerAllocated State
--------- ------ ------ ------- -------------- -----
Gi0/1/7 auto IEEE-4 On 15.400 Watts PHONE

--

NAME: "8 Port GE POE EHWIC Switch on Slot 0 SubSlot 1", DESCR: "8 Port GE POE EHWIC Switch"
PID: EHWIC-D-8ESG-P , VID: V01 , SN:

NAME: "C1941 AC-POE Power Supply", DESCR: "C1941 AC-POE Power Supply"
PID: PWR-1941-POE , VID: , SN:

thanks for any possible update

[balaji.bandi]

Look at the AP power requirements :

https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9100-access-points/215467-cisco-access-point-power-requirements-qu.html