cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
658
Views
0
Helpful
2
Replies

%C6K_POWER-SP-6-NOLPP

robertdog
Level 1
Level 1

Just installed WS-X6724-SFP into my 6506 and got this message. Should I be concerned. In researching it appears that no action is to be taken. Does that mean that power is currently not enabled but as you plug an sfp in power will be granted. Just want to make sure.

Thanks

2 Replies 2

Richard Michael
Cisco Employee
Cisco Employee

Can you please post the entire error message ?

Amit Aneja
Level 3
Level 3

%C6K_POWER-SP-6-NOLPP: Because of lack of system power, devices that require the system to

power them on may not come up within one second.

This message indicates that the local power pools have been deallocated. The module

firmware cannot power up the device until it has received authorization for power

allocation from the software running on the supervisor engine.

Please share the o/p of "show mod", "show power","show environment" & "show log" from the switch.

It looks like that the system doesn't have enough power to bring up this module.

Review Cisco Networking for a $25 gift card