callmanager module ws-x6608

[wharrison]

I just instal a ws-x6608t1 module in my 6513 catalyst switch and it would not power up. I ran the command power enable module but it is still not powered up. My 6513 runs 12.1 ios operating system with two sup engines. can sum one help me.

[dan.gregoire]

All the documentation that I've seen state the WS-X6608T1 is only supported on CatOS and not on IOS. Here is a link that shows this:

http://www.cisco.com/en/US/products/hw/switches/ps708/products_white_paper09186a00800c8441.shtml

The HW/SW compatibility matrix stated the same thing with only CatOS's supporting the WS-X6608.

http://tools.cisco.com/Support/Fusion/FusionHome.do

I hope this helps