cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
18480
Views
13
Helpful
17
Replies
Beginner

Can ping Internet but can't browse it

Remove the lines

no ip virtual-reassembly in

from interface vlan 1

&

Interface Dialer0

Post the output of

show ip nat translation

show ip interface brief

show interface dialer 0

I would also call the ISP and inquire for the DNS IP and enter the same instead of 8.8.8.8 or 4.4.2.2

Hope this helps

Vishal

Highlighted

Can ping Internet but can't browse it

Hello everybody

I tried to remove the virtual reassembly commands from both vlan 1, vlan 2 and di0 but no results.

In my initial config there was ip tcp adjust-mss 1452 on vlan 1 and mtu 1492 on di0 but it didn't work. I tried to remove it and, how it didn't work, I configured them again but no results again.

I can't paste the output of shows int and ip nat trans because the customer has cancelled the project. Today it's going to be one of these days. Thank you all for the interest shown

DAni

Beginner

works with this. thanks

works with this. thanks

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards