cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
396
Views
0
Helpful
3
Replies

can reach different subnets between two routers?

baselzind
Level 6
Level 6

i have server1 in "network 1 vlan30" behind a router "CME" which is  its default gateway also it is a cme , im trying to reach server2 "network 2 vlan 1" in an another subnet behind another router"R1" which is also server 2 default gateway , i can reach server 2 from server 1 but i cant reach server 1 from server 2? 

 

also server 1 can ping R1 network 2 address 

and server 2 can ping cme network 1 address

 

could it be because cme just have a interface vlan for network 2 on it not a physical port?

3 Replies 3

balaji.bandi
Hall of Fame
Hall of Fame

Do you have Routing from server 1 from server 2

 

Like you have route below ?

ip route 10.0.0.0 255.255.255.0 20.0.0.254

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

from server 1 from server 2? can you rephrase the question please

The diagram doesn't match the config of the routers CME and R1 and the configs also look incomplete in regard to forwarding/NAT. Please draw a new diagram with complete interface- and IP information how the network should be implemented and then we can go on troubleshooting that.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco