Hi
I want to change the IOS of my Cisco7206vxr Router which have a NPE-G2 installed in it.I want to change the IOS to c7200p-ipbase-mz.124-15.T7.bin . But after I upload the new file into the router the router continiously saying the following error messages :-
%SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.
loadprog: bad file magic number: 0x0
boot: cannot load "cisco2-C7200"
System Bootstrap, Version 12.4(12.2r)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2006 by cisco Systems, Inc.
Socket jumper: not present Failsafe jumper: present = normal
FPGA revision 0x00000026
C7200 platform with 2095104 Kbytes of main memory
Readonly ROMMON initialized
loadprog: bad file magic number: 0x0
boot: cannot load "disk2:c7200p-ipbase-mz.124-15.T7.bin"
System Bootstrap, Version 12.4(12.2r)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2006 by cisco Systems, Inc.
Socket jumper: not present Failsafe jumper: present = normal
FPGA revision 0x00000026
C7200 platform with 2095104 Kbytes of main memory
Readonly ROMMON initialized
string is disk2:c7200p-ipbase-mz.124-15.T7.bin
loadprog: bad file magic number: 0x0
boot: cannot load "disk2:"
System Bootstrap, Version 12.4(12.2r)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2006 by cisco Systems, Inc.
Socket jumper: not present Failsafe jumper: present = normal
FPGA revision 0x00000026
Lastly the prompt which I am getting is Router(boot)>.
What is the actual problem and how can it be solved.
Any help is most welcome.
Abhishek Pal
