06-22-2009 12:59 PM - edited 03-04-2019 05:12 AM
Hi everyone
now that I passed my CCNA, I would like to set up a LAB.
here is what I have
2x 2610 routers
1x 2501 router
2x2900 switches
1x access severs
now I would like to setup a full lab including frame relay , I would like you help
first question is do I have enough devices to make this happen.
2nd= I would like to start by creating frame relay first and then build up on that. unless if you have a better lab or suggestions.
again Thanks
06-24-2009 02:07 PM
CCNP has very little frame relay in it. It is more into redundancy technologies.
For the switching module, you will need 2x layer 3 (3550, 3560 or 3750) switches and I would recommend replacing the 2900s with at least 2950s.
For the routing module, you will need up to 5 routers. The 2610s will do fine. If the 2501 has 16mb ram/flash, you can place 12.3(26) on it and I think it will do BGP. It will do OSPF and should be fine.
There is a excellent lab book available from Cisco to show the setups for your labs.
Scotty
06-26-2009 11:35 AM
Check out Wendell's blog for all the lab info you'll ever need.
03-23-2019 03:42 AM - edited 03-28-2019 12:49 AM
CCNP certification validates the knowledge and skills to plan, implement, verify and troubleshoot local-area networks (LANs) and wide-area networks (WANs) at the enterprise level. CCNP certified pros can effectively collaborate with specialists on advanced security, voice, wireless and video solutions.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide