Change CISCO 1603 by cisco 801??

[fitou0013]

Hello,

I have buy a new CISCO 801 for change mys CISCO 1603.

I save my configuration but when I restore it on the 801 it's not good.

My CISCO 1603 was IOS 11 and my CISCO 801 IOS 12.1.

Can you help me??

I joint my configuration

[Harold Ritter]

Can you tell us what doesn't work. From what I can see only the physical interfaces (ethernet0 and bri0) might need to be changed to fit the 801.

Hope this helps,

[fitou0013]

Hello,

When I initialize the 801 i have two interface Ethernet0 and BRI0.

On BRI0 I add "no shutdown"

But on the 1603 there isnt this parameter.

THe links are OK.

The routeur can connect to the remote network.

Sorry I not a specialist CISCO

[Harold Ritter]

You should be fine then. The "no shutdown" is just to activate the interface and is not required if the interface is already activated.

Hope his helps,

[fitou0013]

Yes of course ;)

I test my configuration with Cisco ConfigMaker and some parameter are not supported..

Can you tell me how debug that on the cisco?