I want to check license status of CISCO867VAE-K9 router, but I am not getting any command to check license.
Please find detail as below and command pushed. Even I have not found any output in SHOW TECH-SUPPORT
Router#sh inv
NAME: "867VAE-K9", DESCR: "867VAE-K9 chassis, Hw Serial#: XXX213XXXXX, Hw Revision: 0.3"
PID: CISCO867VAE-K9 , VID: V02 , SN: XXX213XXXXX
Router#sh version
Cisco IOS Software, C860 Software (C860VAE-ADVSECURITYK9-M), Version 15.2(4)M6, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2014 by Cisco Systems, Inc.
Compiled Wed 19-Mar-14 18:40 by prod_rel_team
ROM: System Bootstrap, Version 15.1(4r)M3, RELEASE SOFTWARE (fc1)
XXX_Delhi uptime is 43 minutes
System returned to ROM by power-on
System image file is "flash:c860vae-advsecurityk9-mz.152-4.M6.bin"
Last reload type: Normal Reload
Last reload reason: power-on
Cisco 867VAE-K9 (BCM6368) processor (revision 0.3) with 234496K/26624K bytes of memory.
Processor board ID GMK213101W9
1 DSL controller
1 Ethernet interface
4 FastEthernet interfaces
2 Gigabit Ethernet interfaces
1 ATM interface
1 Virtual Private Network (VPN) Module
255K bytes of non-volatile configuration memory.
57344K bytes system flash allocated
Configuration register is 0x2102
Router#show lic?
% Unrecognized command
Router#show l
% Ambiguous command: "show l"
Router#l?
*lo=logout
lock logging login logout
Router#lic?
% Unrecognized command
Router#lic?
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#l?
l2 l2tp l2tp-class li-view
line logging login login-string
