I have the 1131 hardware manual and it is stating that this is caused by a boot loader issue or the ap did not get the IOS file from the controller. Can anyone please shed some light on this as to what might had happen. We have a cisco 4404 controller that this AP reports to. It was one out of 30 and after a reboot it is working fine. What can i do in the future to catch this and prevent this from happening.
P.S.: If this not not he area where i need to be posting this please inform me where i need to do that at.
Hello guys.I installed remote access VPN on Windows 2019. I need to do additional configuration on the router to allow access outside. I got this.Public IP--------------ISP Router-------------Fa0/0 Cisco Router Fa0/1------------------------My Server ...
Meet the Authors video - How to Troubleshoot Network Problems with Vinit Jain
(Live event – Wednesday, February 12th, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 7:00 p.m. Paris)
This event had place on Wednesday 12th, February 2020 at 10hrs PDT&nbs...
I have a pair of 3945 routers that are proving to be underpowered for the 100+ remote offices connecting to them. Fortunately I happen to have a couple of 4351 ISRs rated for significantly greater encrypted throughput. Is there any way I could upgrade the...
This article assumes you have the basic knowledge and experience with Cisco DNA Center and Identity Services Engine (ISE).Note when reading this doc the "Authentication Policy" referred to is part of Cisco DNA Center Onboarding section and ha...