cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2316
Views
0
Helpful
20
Replies
AgentTyler
Beginner

Cisco 1751 router stuck in rommon

I do not have a cross over cable and have to use xmodem. I set the baud rate to 115200 and I can see everything fine. Using Tera Term when you send the file via xmodem it freezes and closes on packet #3 or about 384 bits. When simply clicking the send file button you get the error- 

*** Reserved LVL 7 Interrupt ***

PC = 0xfff0bc98, Vector = 0x500, SP = 0x80004c4c

Not sure what to do from here. I have tried everything.

Error you get when you boot the router:

System Bootstrap, Version 12.2(1r)XE1, RELEASE SOFTWARE (fc1)

TAC Support: http://www.cisco.com/cgi-bin/ibld/view.pl?i=support

Copyright (c) 2001 by cisco Systems, Inc.

C1700 platform with 32768 Kbytes of main memory

loadprog: bad file magic number:      0x0

boot: cannot load "flash:"

“All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can’t get them together again, there must be a reason. By all means, do not use a hammer.” – IBM M
20 REPLIES 20
Leo Laohoo
VIP Community Legend

"magic number" means the IOS file is corrupt.