12-23-2010 05:04 AM - edited 03-04-2019 10:52 AM
Hello everyone,
I would like to connect my 1841 to the equipment that has RS-422 interface in order to transmit data. I have to buy one WIC-1T to support it. However, I am not sure that this module will be able to support RS-422 or not (As I can see there is DB25 which is the interface of RS-422, but I realize that RS-232 also has 25 pins.)
Anynone has experienced this scenarios before?
I appreciate you help, thank you very much.
Pawin
Solved! Go to Solution.
12-23-2010 11:27 AM
To what are you connecting? RS-422 on 25 pins (EIA-530) is an uncommon interface.
However, the cable is: CAB-530MT= (Male DTE).
12-23-2010 11:27 AM
To what are you connecting? RS-422 on 25 pins (EIA-530) is an uncommon interface.
However, the cable is: CAB-530MT= (Male DTE).
12-23-2010 10:44 PM
Thank you very much Paolo. I'm going to connect the cisco router to a radio transmitter which has RS-422 interface.
I could not see anything on the datasheet of WIC-1T which says it could support RS-422, do you think it will work?
Cheers,
Pawin
12-24-2010 01:47 AM
You should be OK then. With different cables, the card supports different types of interface.
Thanks for the nice rating and good luck!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: