Cisco 1941 ISR Router with ISDN/BRI

[Geo Gon]

Is there any card that can support BRI on the ISR1941?

Thanks

[Karsten Iwen]

All supported modules are listed on the "Interfaces & Modules" page. And yes, the WIC-1B-S/T-V3 is supported.

[Geo Gon]

Thanks for your reply.

What I need is a card that I can use for voice. I need to connect them to the PSTN using BRI/ISDN. Would this card work?

Thanks 

[Karsten Iwen · Accepted solution]

It's listed on the same page: VIC2-2BRI-NT/TE

[Geo Gon]

Thanks again Karsten, 

Any tips with the config? 

Te scenario is: 

CISCO_CME---ROUTER_BRI  -----to-----  BT_TELECOM_PSTN

[Geo Gon]

In my scenario, should I configure TE or NT, since I'm connecting to my PSTN?

Thanks