Cisco 1941 Router PPPoE ADSL Conf

[hurolonen]

Hi

I m getting the below debug log and can not get IP from my ISP. It is static IP address and there is modem in bridge mode for the adsl line. Can everyone please suggest what is missing?

Thank you in advance,

Below Conf and debug out put

interface GigabitEthernet0/1

no ip address

duplex auto

speed auto

pppoe enable group global

pppoe-client dial-pool-number 2

end

chg-tr-ixxx-01-e-01#

chg-tr-ixxx-01-e-01#sh run int di2

Building configuration...

Current configuration : 482 bytes

!

interface Dialer2

bandwidth 512

ip address negotiated

no ip redirects

no ip proxy-arp

ip mtu 1492

encapsulation ppp

no ip route-cache cef

load-interval 30

dialer pool 2

dialer-group 2

ppp authentication chap pap callin

ppp chap hostname myusername

ppp chap password 7 050807011E4857080D04

ppp pap sent-username myusername@griddsl password 7 110A180B2816120D102B

end

We are getting below error in Debug logs

May  3 13:42:19.064 UTC: Vi2 PPP: Outbound cdp packet dropped, NCP not negotiated

[paul driver]

Hello
you say its a static ip adddress but you have enabled the dailer int for dhcp?

can you post the whole config if the router?

also try turning off both devices then turn the modem back on first.

res
paul

Sent from Cisco Technical Support Android App

[hurolonen]

thanks for the reply pdriver,

this is the whole configuration. have you ever faced such behaviour before?

[johnlloyd_13]

hi,

was it working before? have you tried reporting the incident to your SP?