Hi Ramoonus,
I am not very clear what is the issue or our objectives of this lab.
As per my understanding you have 2 routers (model c2501). Say A and B.
On the Ethernet of router A you have 10.0.0.0/16 network and on Ethernet of Router B you have 10.2.0.0/16 network. Bother the router are connected by a Serial link using db60 cable.
You objective (I think) are to establish connecting between the two Ethernets subnet that is 10.0.0.0/16 and 10.2.0.0/16.
If so then here is the solution.
1) You need to assign IP address in the serial interface of both routers.
2) Configure routing on both the routers (either static or dynamic).
For point ONE command is
On router A
On the serial interface mode
IP address 192.168.1.1 255.255.255.0
No shut
Exit
On router B
On the serial interface mode
IP address 192.168.1.2 255.255.255.0
No shut
Exit
For second (static)
On router A (this is static default route)
In the configuration mode
IP route 0.0.0.0 0.0.0.0 192.168.1.2
On router B
In the configuration mode
IP route 0.0.0.0 0.0.0.0 192.168.1.1
Dynamic
On router A
In the configuration mode
Ip classless
Router rip
Network 10.0.0.0
Network 192.168.1.0
Version 2
Exit
On router B
In the configuration mode
Ip classless
Router rip
Network 10.2.0.0
Network 192.168.1.0
Version 2
Exit
Do rate the solution if it works
