I wanted to configure trunk link between AP and Cisco Switch. When i make the link trunk then I am not able to ping the Switch.
Can someone help me configuring Access Point.
We have only 1 vlan i.e. 300 and want to configure SSID for this VLAN on Cisco 2600 Access point.AP, Cisco, Erro
Thanks & Regards,
Hope you looking to have Autonomous AP with a single device? If yes try
Below Steps help you :
1. Do you have Right IOS image to configure Autonomous AP?
2. Connect the console cable to AP
3. Reset to Factory Default AP
4. connect the laptop with IP address 10.0.0.10 (configured)
5. configure the AP
with IP address example : 10.0.0.1 255.255.255.0
Follow below Guide :
First check whcih image you have:
Local mode AP must be connected to access ports.
Autonomous mode AP must be connected to trunk port.
Dont forget to rate helpful posts
have a look at the sample configuration below: