cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

1862
Views
30
Helpful
20
Replies
Hall of Fame Community Legend

Cisco 2911 port gone bad?

That's wierd.


And the configuration for the interface Gig 0/1 on the router has speed and duplex set to "auto"?

Highlighted

Cisco 2911 port gone bad?

Yessir, that is correct. I found it very strange as well especially seeing the interface flap onto 100/half as i posted in a few posts above.

Hall of Fame Community Legend

Cisco 2911 port gone bad?

Ummmmm ... I am not sure what's going on.

I'll wait for others to chime in but I'm suspecting you've got a rare faulty Ethernet port on the router.

Cisco 2911 port gone bad?

No problem Leo,

Thanks so much for your input and your assistance.

It is very much appreciated.

Cisco 2911 port gone bad?

Would like to just bump this thread to see if there are any other options I have in order to test and confirm this being a defective port.

Thanks again.

Hall of Fame Master

Cisco 2911 port gone bad?

Gian-Luca Casella wrote:

Would like to just bump this thread to see if there are any other options I have in order to test and confirm this being a defective port.

You have been helped very effectively by Leo, even if no rating was left for his great efforts.

If you still have doubts your next stop should be Cisco TAC.

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards