Cisco 2911 port gone bad?

[Leo Laohoo]

That's wierd.

And the configuration for the interface Gig 0/1 on the router has speed and duplex set to "auto"?

[Gian-Luca Casella]

Yessir, that is correct. I found it very strange as well especially seeing the interface flap onto 100/half as i posted in a few posts above.

[Leo Laohoo]

Ummmmm ... I am not sure what's going on.

I'll wait for others to chime in but I'm suspecting you've got a rare faulty Ethernet port on the router.

[Gian-Luca Casella]

No problem Leo,

Thanks so much for your input and your assistance.

It is very much appreciated.

[Gian-Luca Casella]

Would like to just bump this thread to see if there are any other options I have in order to test and confirm this being a defective port.

Thanks again.

[paolo bevilacqua]

Gian-Luca Casella wrote:
Would like to just bump this thread to see if there are any other options I have in order to test and confirm this being a defective port.

You have been helped very effectively by Leo, even if no rating was left for his great efforts.

If you still have doubts your next stop should be Cisco TAC.