05-01-2014 11:58 AM - edited 03-04-2019 10:53 PM
Hello,
I have a Cisco 2921/K9 and technology package "securityk9" added to it. But when I try to run "pfr" command on the router it is not available. I assumed SEC/K9 license should give pfr capability on this router. Could you please confirm? I am running "flash0:c2900-universalk9-mz.SPA.152-4.M4.bin" IOS on this router.
License Info:
License UDI:
-------------------------------------------------
Device# PID SN
-------------------------------------------------
*0 CISCO2921/K9 XXXXXXXX
Technology Package License Information for Module:'c2900'
-----------------------------------------------------------------
Technology Technology-package Technology-package
Current Type Next reboot
------------------------------------------------------------------
ipbase ipbasek9 Permanent ipbasek9
security securityk9 Permanent securityk9
uc None None None
data None None None
Configuration register is 0x2102
Thank you.
05-01-2014 12:18 PM
I think I am missing the "data" license where the pfr feature resides for ISR G2.
05-15-2015 04:05 AM
Hi Shivani,
The way you activate your license for Evaluation period of 60 days type in the following commands.
Router(config)# license accept end user agreement
Hit yes
Router(config)# license boot module c2900 technology-package ?
datak9 data technology
securityk9 security technology
uck9 unified communications technology
For PfR I used datak9 and hit enter and then reloaded the router.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: