cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1784
Views
0
Helpful
9
Replies

CISCO 2921 to Level3 Fast E, download speed is low

bc4switch
Level 1
Level 1

Our ISP is Level3 and we have 100Mpbs Fast E line.

However, with various speed testing tools, we never got better that 20Mbps download speed.

Upload speed is usually better than download speed.

Also, using Level3 suggested testing tool: testmy.net, upload is almost 4 times faster that download speed.

Per Level3, we hard code our router interface speed to 100, duplex to full.

Appreciate any opinions or past experiences.

9 Replies 9

John Blakley
VIP Alumni
VIP Alumni

Can you double check that your interface is really 100/full? If you have it specifed and they don't, it will negotiate at half duplex. Also, do you have any rate policies on the interface or anything in front of your router like a packetshaper, load balancer, etc?

HTH,
John

*** Please rate all useful posts ***

HTH, John *** Please rate all useful posts ***

show interface displays that the interface is running Full-duplex, 100Mb/s. The router is directly connected to Level3 demarc point, not rate policies on the interface.

Can you post "show int"?

HTH,
John

*** Please rate all useful posts ***

HTH, John *** Please rate all useful posts ***

GigabitEthernet0/0 is up, line protocol is up

  Hardware is CN Gigabit Ethernet, address is xxxc.111c.xxx0 (biaxxxc.111c.xxx0)

  Internet address is 4.4.4.250/30

   MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA, loopback not set

   Keepalive set (10 sec)

  Full-duplex, 100Mb/s, media type is RJ45

  output flow-control is unsupported, input flow-control is unsupported

   ARP type: ARPA, ARP Timeout 04:00:00

  Last input 00:00:22, output 00:00:00, output hang never

  Last clearing of "show interface" counters never

  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

  Queueing strategy: fifo

   Output queue: 0/40 (size/max)

  5 minute input rate 6000 bits/sec, 3 packets/sec

  5 minute output rate 5000 bits/sec, 4 packets/sec

     2468579 packets input, 1155793856 bytes, 0 no buffer

     Received 19453 broadcasts, 0 runts, 0 giants, 0 throttles

     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

     0 watchdog, 19340 multicast, 0 pause input

     0 input packets with dribble condition detected

     2757272 packets output, 1846809806 bytes, 0 underruns

     0 output errors, 0 collisions, 2 interface resets

     19340 unknown protocol drops

     0 babbles, 0 late collision, 0 deferred

     2 lost carrier, 0 no carrier, 0 pause output

     0 output buffer failures, 0 output buffers swapped out

I was primarily looking for crc errors on the interface which you don't have. It sounds like you need to go back to the provider and explain the situation. From your output above, I don't see any issues. What about the system that you were doing the speed test from? Is there any other equipment between this router and the switch that your workstation was connected to like a Packetshaper or load balancer of some sort?

HTH,
John

*** Please rate all useful posts ***

HTH, John *** Please rate all useful posts ***

We have 50 MB Link , We Have tested the Link on PC then it's getting full downloading speed (50 MB)  but Via router it's not getting Full speed (32 MB)..

Please suggest !

The provide reboot their end of switch already.

The provider is telling the same story, not seeing any issues! But we purchased 100Mbps line, we get slow download speed no matter what. Thanks for you input.

vmiller
Level 7
Level 7

Might be the workstation configuration.

http://www.ipbalance.com/traffic-analysis/traffic-analysis-general/239-internet-speed-issue-throughput-vs-bandwidth.html

      

There is a pretty good discussion in there regarding window size etc etc.....

rtjensen4
Level 4
Level 4

Can you connect a workstation directly to the handoff from L3 and test that way? would rule out anything on the router.

Review Cisco Networking for a $25 gift card